Home » Vending Miser » Snack Miser » USAT SnackMiser Slave Unit, Model SM171
USAT SnackMiser Slave Unit, Model SM171
Yes! Available up to 6 units 
USD (change) 
Shipping Information:
Arrives:
Sep 23
Arrives:
Sep 22
Arrives:
Want to get the Misers installed quickly, without the need to move the machine or install the sensors on the wall? Check out this EZ Install Model. Every unit comes with the PIR sensor mounted to the top of a metal bracket and velcro, to install the bracket to the top of the machine. Just attached the bracket, plug in the vending machine to the Miser and the Miser to the wall plug and you are finished! 5 minute installations are common with the EZ Install bracket.
The SM171 is the Slave SM151 unit combined with the E-Z install bracket for quick and simple installation.
The Bad:
The Bottom Line:
Full Review
Invisible to the User - equipment is powered up when the user enters the area, and is powered down when the area is vacant.
Rugged 10A Capacity - SnackMiser can control any snack machine.
Easy To Install - SnackMiser’s embedded Sensor Repeater makes installation fast and simple. The new Easy-Install SnackMiser allows installation with no tools required.
SnackMiser is proudly Made in the USA.
Electrical Specifications
Input Voltage: 115 Volts
Input Frequency: 50/60 Hz
Maximum Load: 12 Amps (Steady-State)
Maximum Load: 1050 Watts (Steady-State)
Power Consumption: Less than 1 Watt (Standby)
Environmental Specifications
Operating Temp: 0 degrees C to 50 degrees C
Storage Temp: - 20 degrees C to 60 degrees C
Relative Humidity: 95% Maxiumum (Non-Condensing)
Compatibility
Snack Vending Machines: Any type, as long as SnackMiser
